JUMO 709051, Operating Manual, Page: 56 / 92

5 Configuration
56 V1.00/EN/00741192/2021-03-30 [IPC 300]
Load monitoring None The load is not monitored.
Undercurrent
Note:
v
Chapter 6.2 "Detection of load faults"
Overcurrent
Limit value
load monitoring Note:
This setting is only available if load monitoring has been set
to undercurrent or overcurrent.
0 to 10 to 100 % Partial load failure or partial load short circuit:
This setting specifies the percentage by which the load resis-
tance must have decreased or increased for a load fault to be
triggered.
Load type
load monitoring Standard Default setting (suitable for most load types)
Infrared radiator
(short-wave) Especially suitable for short-wave infrared radiators
Teach-In type load
monitoring Manual Teach-In can be performed in manual mode or in the operat-
ing level.
v
Chapter 6.3.2 "Configuring Teach-In (prerequisite for
Teach-In in manual mode)"
v
Chapter 4.2.5 "Binary inputs"
Automatically once The Teach-In value is automatically determined once after
each power ON.
v
Chapter 6.2.1 "Teach-In"
Automatic (cyclically) Teach-In is performed cyclically at a time interval of 1 minute.
This setting is particularly suitable for SiC heating elements.
SiC
monitoring No No monitoring
Yes This setting for the monitoring of SiC heating elements uses a
binary signal to indicate when the power required by the set-
point specification can no longer be reached with the load
present, due to aging of the heating elements.
This error is shown in the info line when the actual value of the
subordinate control loop is smaller than the required setpoint
value for an uninterrupted period of 7 minutes.
v
Chapter 8 "Error messages and alarms"
k
/ bold = default setting