Javad TRIUMPH-LS, User Manual

Page: 163 / 168

To turn ON the receiver press the power button. To turn OFF the receiver, press and hold
the power button until LEDs are off and then release the button.
The MinPad is the receiver’s minimum interface used to display and control data
input and output.
TRIUMPH-2
Start Guide
USB port
is used for high-speed
data transfer and communication be-
tween the receiver and an external
device.
Power port is used to connect
the receiver to an external power
source and to charge the batteries.
Input voltage: +10...16 VDC.
Function Symbol Green Yellow Red OFF
BATTERY
1
Full Half Almost empty OFF/No power
WLAN Connected Initialization Error Not Active
SATELLITES
2
8 or more 5 to 7 Less than 5 No Satellite
POSITION
Fixed/Diff/
OK (Base)
Float/No-Diff No Position Receiver OFF
RECORDING
3
Recording Less than 10
min memory left Memory Full
Not Active
1.Blinking every 1 sec according to the battery means receiver is ON without external power. LED solid according to the battery means
external power is connected.
2. Effective number of satellites are total number of satellites tracked minus the number of non-GPS systems tracked. For example if
8 GPS and 5 GLONASS are tracked the effective number of satellites is 12.
3. RECORDING LED blinks on each recording.
Function Symbol Blue Yellow Red OFF
BLUETOOTH Connected Searching No connection Not Active
The record button
starts/stops data
recording.
Revision 1.3 from May 28, 2014
www.javad.com
163
Appendix A - Blinking LEDs Explained
Appendix A - Blinking LEDs
Appendices