item Controller BL 1-04 /C
― Product manual
106
Group 81: IRQ_4_5
81-4
Time overflow low-level IRQ
Please contact the Technical Support team.
Group 82: Internal sequence control
82-0
Sequence
Internal sequence control: The process was aborted.
For information only. No measures required.
82-1
Concurrent CO write access Please contact the Technical Support team.
Group 83: Technology modules
83-0
Technology module: slot/
combination
The technology module cannot be used in the current slot or the combination of
technology modules is not permissible.
Contact the Technical Support team.
83-1
Technology module not
supported
Load the most recent firmware.
83-2
Technology module: HW
revision not supported
Load the most recent firmware.
83-3
Service module: write error
Please contact the Technical Support team.
83-4
MC2000 Watchdog
Please contact the Technical Support team.
Group 84: Internal sequence control
84-0
Conditions for controller
enable not fulfilled
Enable the servo drive again after a short period of time. If the error recurs,
check the following:
▪ Are there still errors?
▪ Is the angle encoder ready?
▪ Has DIN4 been set?
▪ Is MOTID still being executed?
▪ Is there a running TFTP download?
▪ Has an energy-saving mode been activated via PROFIenergy?
▪ Does the FSM 2.0 – MOV (SBC) block the enable signal?
