OPERATION
65
DRAWBAR
FIG. 5-56:
Drawbar, 1, at rear of Tractor allows pull-
type implements to be attached to Tractor. Maximum
vertical load on drawbar must not exceed 880 lbs
(400kg).
CAUTION: Pulling heavy loads will require
extended braking distances. Reduce
travel speed.
Make sure attachment is properly secured and safety
chain is used.
NOTE: When using three-point hitch, it may be
necessary to remove drawbar by removing
clips and pins, 2, and sliding drawbar from
bracket to improve operating clearance. This
is particularly true with mounted implements
using PTO drive.
Seat
FIG. 5-57:
Please ask the your dealer if you have
any question concerning seat. Just for your informa-
tion, depend on your resident area, seat belt will be
required to equip as standard.
Detaching Implements
CAUTION: Always use POSITION CON-
TROL to attach/detach implements to
provide precise control of hitch.
Select a level area to detach and store the implement.
Lower implement to ground by moving position control
lever to DOWN. If necessary, adjust leveling crank on
right lift link to level implement on ground.
Shut off engine, securely lock brakes and remove key
from Tractor.
Disconnect implement PTO drive shaft (as applicable).
Detach top link from implement and place in storage
position on Tractor by engaging spring on top link in
slot in rear center panel.
NOTE: Lengthening or shortening of top link may
be required to permit disconnection from
implement.
FIG. 5-56
FIG. 5-57
1
2
Summary of Contents for TH4295
Page 1: ...TH4295 TH4335 TH4365 MODELS I S E K I T R A C T O R S ...
Page 3: ......