TH4295,4335,4365
64
CAUTION: Make sure all hydraulic hoses,
couplers and cylinders are in good condi-
tion before use.
FIG. 5-52:
Most implements require double-acting hy-
draulics. Each implement cylinder will have two hoses
connected to it.
When single acting service is required (cylinder with
only one hose), the upper coupler will be used. The
selector function, 1, must be turned to the left. The se-
lector function is located at the right rear of the tractor
on the back of the valve spools.
NOTE: For
normal double-acting operation selector
function must be turned to the right.
ROLL-OVER PROTECTIVE STRUCTURE (ROPS)
FIG. 5-53:
This tractor is equipped with a foldable roll-
over protective structure (ROPS), 1, and seat belt.
The seat belt should be worn at all times when tractor
is being operated with the ROPS in the upright, locked
position.
CAUTION: Do not weld, drill, bend or
straighten damaged ROPS. Make sure
all components are in correct working
order in order to provide the intended
protection.
Only original bolts and pins, or equivalent
replacements, must be used and tight-
ened to the correct torque value. Make
sure the hinge joint is properly secured.
FIG. 5-54:
When overhead clearance is restricted, the
upper portion, 2, of the ROPS may be folded down.
FIG. 5-55:
To fold the upper portion of the ROPS, re-
move the locking pin, 1, and lower the upper portion.
The seat belt should not be worn when operating with
the ROPS folded down.
WARNING: No roll-over protection is pro-
vided when the ROPS is folded down.
Drive with extreme care. Tractor roll over
may result in serious injury or death.
Adjust the rubber isolator, 3, on the upper-front of the
lower U-frame to reduce viblation. Tighten the jam nut.
1
1
FIG. 5-52
FIG. 5-53
FIG. 5-54
FIG. 5-55
Summary of Contents for TH4295
Page 1: ...TH4295 TH4335 TH4365 MODELS I S E K I T R A C T O R S ...
Page 3: ......
