![Iseki TH4295 Operation Manual Download Page 108](http://html.mh-extra.com/html/iseki/th4295/th4295_operation-manual_2092555108.webp)
ASSEMBLY & PRE-DELIVERY INSPECTION
105
d. Connect the wire from lamp of number plate and
damp on the frame.
e. Install and secure the upper frame of ROPS to
the lower frame.
Tightening torque: 73.7-88.3 N•m (750-900 kgf•cm)
f. Insert the pins.
6. Front Bumper - Install front bumper and secure with
four bolts supplied in sundry box.
7. Install the rear view mirror. Position of mirror (LH or
RH) is according to the local regulation.
After attaching light, attach electrical connectors to
connectors located at fender and ROPS support.
8. Seat - Remove bolts from seat frame and install
seat using same hardware.
If it is required to equip the seat belt, please ask
your local dealer.
9. Three-Point Hitch - Three-point hitch is partially as-
sembled, with lift links attached at the top to the lift
shaft, and away chains attached to the lower links.
a. Attach lower links to Tractor attaching points
and secure with lynch pins. Lower links will flare
out ward t rear and retaining rings for spring will
locate at underside.
b. Connect clevis end of check chains to axle brack-
ets and secure with clevis pin and cotter pin.
c. Remove bolts at lower end of lift links and attach
lift links to identical positions on lower links using
bolts, lock washers and nuts removed. Lift link
with turnbuckle adjustment is located on right
side.
IMPORTANT: Bolts should be installed with heads
to out-side (nuts on inside) of lift link,
to prevent tire interference during
operation.
d. Connect top link to anchor point on Tractor using
19 mm x 220 mm pin and lynch pin. Lock nut on
top link barrel will locate to rear. Store top link
implement pin (19 mm x 86 mm) and clip in rear
end of top link.
e. Connect spring to retaining rings at underside of
lower links.
10. Drawbar - Install drawbar fully into bracket at rear
of Tractor and secure with pin and clip provided.
11. Front Wheels -
a. Carefully raise and block front of Tractor.
b. Install wheel / tire assemblies and secure us-
ing bolts and lock washers. Tighten to 75 ft-lbs.
(102 Nm).
c. Remove blocking and lower front of Tractor.
FIG. 9-5
Summary of Contents for TH4295
Page 1: ...TH4295 TH4335 TH4365 MODELS I S E K I T R A C T O R S ...
Page 3: ......