Iseki TH4295, Operation Manual

Page: 34 / 113

INSTRUMENTS & CONTROLS
31
NOTE: Turn lights will not self-cancel. Select turn/
hazard light switch to center position after
completing turn.
FIG. 4-11: Hazard Light Switch, - Press switch, 10,
to turn on hazard lights. Both flashing amber warning
lights will operate at the same time.
CAUTION: Hazard lights must be used any
time Tractor is driven on public roadway.
Consult local agencies for other marking
requirements.
FIG. 4-12: Turn/hazard indicator lights, 11 and 12,
will operate with ROPS-mounted warning lights. This
provides operator with easy indication of warning light
selection.
Power Take-Off (PTO) Switch (K-type, HST-type)
FIGS. 4-13 & 4-14: A dial-type safety switch, 1, is
used to engage and disengage the PTO drive system.
The switch must first be turned to right and then pulled
up to engage PTO. When engaged, the PTO indicator
light in the indicator light strip will illuminate.
A PTO selectable switch, 2, is used to adjust PTO
clutch modulation.
Push on: soft start (button depressed illuminated) - for
high inertia loads
Push off: standard start (button out and not illuminated)
IMPORTANT: PTO switch is equipped with a lock-
out to prevent accidental engagement
of PTO system. To engage PTO, first
turn switch clockwise and then pull up
it. DO NOT FORCE SWITCH.
NOTE: PTO switch, 1, must be used in conjunction
with rear PTO selector lever, to left of opera-
tor’s seat, when rear PTO is used. Refer to
“Operation” section for complete details.
When PTO control switch is “ON” the engine
cannot be started. Always switch off PTO and
depress main clutch pedal to start engine.
This switch is eguipped with only “Indepen-
dent PTO” sepecification model.
“Independent PTO” is not eguipped on “Cen-
ter ROPS” model and “V” type tractor.
WARNING: Always shut off PTO and shut
off Tractor engine before servicing PTO-
driven implement. Allow all movement
and motion to stop before leaving opera-
tor’s seat.
FIG. 4-11
FIG. 4-12
FIG. 4-13
FIG. 4-14
11 12
1
2
10