TH4295,4335,4365
104
ASSEMBLY
IMPORTANT: Do
not commence assembly of this
Tractor until reading these instructions
completely and carefully.
NOTE: For certain lubrication, adjustments, etc.,
refer to appropriate section of this booklet.
All nuts, bolts, etc., on these Tractors are
METRIC dimensions.
Tractor is shipped in individual container. The Tractor
will be partially disassembled to make container as
compact as possible. Wheels, fenders, ROPS, steer-
ing wheel, lift linkage, drawbar, and some attaching
hardware will be removed.
Larger items will be fastened in container and remain-
der of items will be shipped in sundry boxes also in
container.
Certain areas of Tractor may be covered with thin
film of protective wax. It may be removed by steam
cleaner and detergent solution during assembly.
Tractor will arrive with battery installed.
To assemble and pre-deliver the Tractor, proceed as
follows:
CAUTION: Be observant of components
(wheels, fenders, ROPS, etc.) that may be
attached to, or held in position by con-
tainer panels.
1. Remove wheels, fenders, and sundry boxes from
container.
2. Disassemble container.
3. Inspect Tractor for damage and any evidence of
coolant, fuel or lubricant leaks.
4. Inspect and remove all hardware securing Tractor
to lower crate panel.
5. Rear ROPS
a. Install and secure the lower frame (ROPS base).
Tightening torque: 73.7-88.3 N•m (750-900 kgf•cm)
b. Install and secure the lamps
Wire
from lamp should be connected with coapler
to the tractor through the hole on the ROPS.
c. When connect the wire, wire harness should be
damped on the lower frame.
ASSEMBLY & PRE-DELIVERY INSPECTION
FIG. 9-1
FIG. 9-2
FIG. 9-3
FIG. 9-4
Summary of Contents for TH4295
Page 1: ...TH4295 TH4335 TH4365 MODELS I S E K I T R A C T O R S ...
Page 3: ......
