Goodrive350 IP55 High-ingress Protection Series VFD
Basic Operation Instructions
-31-
No. Name
Instruction
with interfaces, eg switch over the monitoring
interface, shifting the cursor rightward, enter
the next menu etc.
3
Display
area
(12)
LCD
Display screen
240×160 dot-matrix LCD; display three
monitoring parameters or six sub-menu items
simultaneously
4
Others
(13)
RJ45
interface
RJ45 interface RJ45 interface is used to connect to the VFD.
(14)
Battery
holder
Clock battery
holder
The battery holder is used for replacing or
installing a battery for the clock.
(15)
USB
terminal
mini USB
terminal
Mini USB terminal is used to connect to the
USB flash drive through an adapter.
The LCD has different display areas, which displays different contents under different
interfaces. The figure below is the main interface of stop state.
Figure 5-2 Main interface of LCD
GD350
16:02:35
Fwd
Local
Ready
Set Freq
P17.00 Hz
50.00
DC Bus Volt
P17.11 V
540.0
0x0000
About
Parameter
Menu
HDIB/A/S4/3/2/1
P17.12
A
B
C
D
E
F
Area
Name
Used to
Header A Real-time display area
Display the real-time; clock battery is not included; the time
needs to be reset when powering on the VFD
Header B
VFD running state
display area
Display the running state of the VFD:
1. Display motor rotating direction: "Fwd"
– Run forward
during operation; "Rev"
– Run reversely during operation;
"Forbid"
– Reverse running is forbidden;
2. Display VFD running command channel: "Local"
–Keypad;
"Terminal"
–Terminal; "Remote"–Communication
3. Display current running state of the VFD : "Ready"
– The
VFD is in stop state (no fault); "Run"
– The VFD is in running
state; "Jog"
–The VFD is in jogging state; "Pre-alarm"–the VFD
is under pre-alarm state during running; "Fault"
–VFD fault
occurred.
Header C
VFD model display
area
Display VFD model: "GD350
– current VFD is GD350 series
VFD
