Multitron Pro - Incubation Shaker
Maintenance
Page
152
of
185
2013-02-19
CAUTION!
Risk of material damage to the incubation
chamber due to splashed water during
cleaning.
If rinsing water is tipped into the chamber without
due care, splashed water can come into contact
with the electrical system and the fans, thus
causing permanent damage.
Therefore:
– Always pour rinsing fluids carefully into the floor
pan.
– Always use a large beaker or similar to pour
rinsing fluids into the incubation chamber.
– Do not use a pressurised water hose for
cleaning.
If necessary:
6
.
Rinse the floor pan with hot water and a mild household
cleaner.
Fig. 109
Rinsing fluids must be drained away through the drain hole at the
side of the unit.
NOTICE!
If the drain is not connected to the in-house
wastewater system, push a hose onto the drain
nozzle and let the water run into an appropriately
sized container.
7
.
Rinse the floor pan with water.
8
.
Thoroughly dry the floor pan with paper towels.
9
.
Lower the table back onto its axle.
10
.
Insert the Allen screws and tighten cross-wise with an Allen
key.
NOTICE!
If any of these Allen screws are lost or damaged,
they must be replaced by original screws. See
chapter Technical Data – General specification.
