ioControl
18
> The 1st digit to be edited flashes�
►
Use the UP and DOWN buttons to set the requested value�
►
Use the ENTER button to go to the next digit�
> The 2nd digit to be edited flashes�
►
Use the UP and DOWN buttons to set the requested value�
►
Use the ENTER button to go to the next digit�
> The 3rd digit to be edited flashes�
►
Use the UP and DOWN buttons to set the requested value�
►
Press the ENTER button�
> The set node ID is confirmed�
> "nodE" is displayed
►
Press the DOWN button�
> "BAUD" is displayed
►
Press the ENTER button�
> The device displays the set baud rate�
►
Use the UP and DOWN buttons to set the requested value�
►
Press the ENTER button�
> The set baud rate is confirmed�
Changes of the parameters are only applied after a reset of the device�
Exit the editing mode:
►
Press UP and DOWN simultaneously for at least 10 s�
> Green Lock LED on�
> Parameters cannot be edited�
> "Loc" is displayed for 5 s, then the set node ID is displayed
If no button is activated for 30 s, the device automatically finishes the editing
mode�
8.1.3 List of parameters
Parameters
Function
Value range
Default value
nodE
Node ID of the device
1���125
125
BAUD
Baud rate
20, 50, 100, 125, 250, 500, 800, 1000
250 kBit/s
