UK
ioControl
17
8 Set-up
8.1 I/O module
On delivery the device is configured as I/O module�
After power on the 10-segment display indicates the article number of the device,
followed by the set node ID�
8.1.1 Display mode
If the green Lock LED is on, the device is in display mode� The device can only
indicate the set node ID and baud rate and, if appl�, error messages; parameters
cannot be edited�
►
Press the DOWN button�
> The device displays the set baud rate�
►
Press the DOWN button�
> The device displays error code 1, if applicable�
►
Press the DOWN button again�
> Every time the DOWN button is pressed, the device displays another error
code, if applicable�
►
Use the UP button to go back�
Max� 4 different error codes can occur and be displayed:
Error code
Description
SH
Short circuit to GND
OP
Wire break
oL
Excessive current
Comm
Communication error
If no button is activated for 10 s, the device displays the set node ID�
8.1.2 Parameter setting
►
Press UP and DOWN simultaneously for at least 10 s to change to the editing
mode�
> Green Lock LED goes out�
> Parameters can be edited�
> "uLoc" is displayed for 5 s
> "nodE" is displayed
►
Press the ENTER button�
> The device displays the set node ID�
