ICP DAS USA UA-5200 Series, User Manual

Page: 65 / 233

UA-5200 Series User Manual V4.3 ICP DAS
65
The finished Modbus Mapping Table as below is in order of DO, DI, AO and AI.
Modbus Mapping Table
– Address Setting
Address Setting The
“Address Setting” page of the Modbus Mapping Table
Nickname
Setting
Click can switch to the The
“Nickname Setting” page of the
Modbus Mapping Table. (Next page)
Modbus
Mapping Table
Coil Status(0x): Mapping to DO Modbus address
Input Status(1x): Mapping to DI Modbus address
Holding Registers(4x): Mapping to AO Modbus address
Input Registers(3x): Mapping to AI Modbus address
Address The start address of the Modbus command. Default: 0. Note: the
address of UA controller is start from 0, even if some modules are
start from 1, here it needs to follow the UA series to start from 0.
Number The number of the Modbus address. Need to give enough number
for the DO, DI, AO, AI channels of the module. At least 1.
Type DO/DI type: Bool (Boolean)
AO/AI type: depend on setting of [Modbus Mapping Table Setting]
Edit Click to change the address and Number.
Delete Click to delete this address table.
Save Click to save and exit this table editing.
Cancel Click to exit without saving and back to the module list page.
OK Click to save this page settings and back to the module list page.