ICP DAS USA UA-5200 Series, User Manual

Page: 144 / 233

UA-5200 Series User Manual V4.3 ICP DAS
144
Module Content Setting
No. The module number in the module list (Not editable here)
Module Name Give a name, e.g. model number or name. Default: Name.
IP The IP address of the connected module. Default: 0.0.0.0
Port The port number for Modbus TCP. Default: 502
Slave ID Set the Slave ID of the UA-5200. (Range: 1 ~ 247)
Timeout Set the timeout value for the module. Default: 500 ms
Polling Rate Set a time interval for the command. Default: 500 ms
Modbus Mapping Table Setting
Data Model System provides 4 Modbus data models
“01” ~ “04” for mapping to address of DO,
DI, AO and AI. (ex. 01: DO channels,
02: DI, 03: AO, 04: AI)
Start Address The start address of the Modbus command. Note: the address of UA
controller is start from 0, even if some modules are start from 1, here it
needs to set follow the UA series to start from 0.
Data Number The number of the Modbus address. Need to give enough number for
the DO, DI, AO, AI channels of the module. Default: 1.
Type This item only when the data model is 03 or 04. Choose the suitable
data type: 16-bit Short, 16-bit Unsigned Short, 32-bit Long, 32-bit
Unsigned Long, 32-bit Float, 64-bit Double.
Create Tables Click [Add] button, it will add a table in the Modbus mapping table.