ICP DAS USA UA-5200 Series, User Manual

Page: 77 / 233

UA-5200 Series User Manual V4.3 ICP DAS
77
[ Module Content Setting ] page can set up the module and the Modbus address
mapping table:
Module Content Setting
No. The module number in the module list (Not editable here)
Module Name Give a name, e.g. model number or name. Default: Name.
Slave ID Set the module Slave ID of the UA-5200. (Range: 1 ~ 247)
Timeout Set the timeout value for the module. Default: 500 ms
Modbus Mapping Table Setting
Data Model System provides 4 Modbus data models
“01” ~ “04” for mapping to address of
DO, DI, AO and AI. (ex. 01: DO
channels, 02: DI, 03: AO, 04: AI)
Start Address
The start address of the Modbus command. Note: the address of
UA controller is start from 0, even if some modules are start from 1,
here it needs to set follow the UA series to start from 0.
Data Number The number of the Modbus address. Need to give enough number
for the DO, DI, AO, AI channels of the module. Default: 1.
Type This item only when the data model is 03 or 04. Choose the
suitable data type: 16-bit Short, 16-bit Unsigned Short, 32-bit Long,
32-bit Unsigned Long, 32-bit Float, 64-bit Double.
Create Tables Click [Add] button, it will add a table in the Modbus mapping table.