IBM HS40 - BladeCenter - 8839, Maintenance And Troubleshooting Manual

Page: 82 / 172

Thermal grease
This section contains information about removing and replacing the thermal grease
between the heat sink and the microprocessor. The thermal grease must be
replaced whenever the heat sink has been removed from the top of the
microprocessor and is going to be reused or when debris is found in the grease.
Note:
v Read “Installation guidelines” on page 33.
v
Read the safety notices beginning on page 109.
v Read “Handling electrostatic discharge-sensitive devices” on page 112.
Complete the following steps to replace damaged or contaminated thermal grease
on the microprocessor and heat sink:
1. Place the heat sink on a clean work surface.
2. Remove the cleaning pad from its package, and unfold it completely.
3. Use the cleaning pad to wipe the thermal grease from the bottom of the heat
sink.
Note: Be sure that all of the thermal grease is removed.
4. Use a clean area of the cleaning pad to wipe the thermal grease from the
microprocessor; then, dispose of the cleaning pad after all of the thermal grease
is removed.
5. Use the thermal grease syringe to place 16 uniformly spaced dots of 0.01 mL
each on the top of the microprocessor.
Microprocessor
0.01 mL of
thermal grease
Note: 0.01 mL is one tick mark on the syringe. If the grease is properly applied,
approximately half (0.22 mL) of the grease will remain in the syringe.
6. Install the heat sink onto the microprocessor as described in “Installing an
additional microprocessor” on page 46.
Processor board
When replacing the processor board, you must either update the system with the
latest firmware or restore the pre-existing firmware that the customer provides on a
diskette or CD image.
Note:
v
Read “Installation guidelines” on page 33.
v
Read the safety notices beginning on page 109.
72
BladeCenter HS40 Type 8839: Hardware Maintenance Manual and Troubleshooting Guide