IBM HS40 - BladeCenter - 8839, Maintenance And Troubleshooting Manual

Page: 96 / 172

Note: See Chapter 7, “Parts listing, Type 8839,” on page 105 to determine which components should be replaced by
a field service technician.
Error code/symptom FRU/action
202-XXX-004
(Failed system cache test)
1. Microprocessor 4
2. System board
217-198-XXX
(Could not establish drive parameters)
SCSI storage expansion unit
217-XXX-000
(Failed hard disk drive test)
Note: If RAID is configured, the hard disk
drive number refers to the RAID logical
array.
Hard disk drive 1
217-XXX-001
(Failed hard disk test)
Note: If RAID is configured, the hard disk
number refers to the RAID logical array.
Hard disk drive 2
405-XXX-000
(Failed Ethernet test on controller on the
system board)
1. Verify that Ethernet is not disabled in BIOS.
2. System board.
Light path diagnostics
Lit blade-error
LED Cause Action
None An error has occurred and cannot be isolated,
or the service processor has failed.
An error has occurred that is not
represented by a Light Path Diagnostics
LED. Check the system error log for more
information about the error.
DIMM error A memory error occurred.
1. Reseat the DIMM indicated by the lit
DIMM failure LED.
2. Replace the DIMM.
Note: Multiple DIMM LEDs do not necessarily
indicate multiple DIMM failures. If more than
one DIMM LED is on, reseat/replace one
DIMM at a time until error goes away. Refer to
the BladeCenter management module system
error log for further isolation.
Processor board
fault
The integrated VRM on the blade server
processor board has failed.
1. Replace the blade server cover, reinsert
the blade server in the system chassis,
and then restart the blade server. (See
“Removing the blade server from the
BladeCenter unit” on page 39 for
instructions).
2. Replace the processor board.
I/O board fault The integrated VRM on the blade server I/O
board has failed.
1. Replace the blade server cover, reinsert
the blade server in the system chassis,
and then restart the blade server. (See
“Removing the blade server from the
BladeCenter unit” on page 39 for
instructions).
2. Replace the I/O board.
86
BladeCenter HS40 Type 8839: Hardware Maintenance Manual and Troubleshooting Guide