IBM HS40 - BladeCenter - 8839, Maintenance And Troubleshooting Manual

Page: 92 / 172

Note: See Chapter 7, “Parts listing, Type 8839,” on page 105 to determine which components should be replaced by
a field service technician.
Error code/symptom FRU/action
84F2
(Server management interface failed)
1. Update the BMC and SDRs with the most current versions that
are compatible with your system configuration.
2. I/O board.
84F3
(BMC in update mode)
1. The BMC recovery jumper is in the active position and the BMC
can be updated.
2. After updating the BMC, move the jumper to the inactive position.
84F4
(Sensor Data Record empty)
1. Update the BMC and SDRs with the most current versions that
are compatible with your system configuration.
2. I/O board.
3. Processor board.
84FF
(System Event Log full)
Clear the System Event Log.
00150900
(SERR/PERR detected on PCI bus.)
1. PCI-X adapter
2. I/O board
00151730
(IMB parity/CRC error)
1. DIMM
2. Processor board
The following errors appear on the screen during POST and in the
management-module error log.
Note: See Chapter 7, “Parts listing, Type 8839,” on page 105 to determine which components should be replaced by
a field service technician.
Error code/symptom FRU/action
Microprocessor 1 internal error (IERR)
1. Run the Configuration/Setup Utility program, and enable the
microprocessor retest.
2. Microprocessor 1.
3. Processor board.
Microprocessor 2 internal error (IERR)
1. Run the Configuration/Setup Utility program, and enable the
microprocessor retest.
2. Microprocessor 2.
3. Processor board.
Microprocessor 3 internal error (IERR)
1. Run the Configuration/Setup Utility program, and enable the
microprocessor retest.
2. Microprocessor 3.
3. Processor board.
Microprocessor 4 internal error (IERR)
1. Run the Configuration/Setup Utility program, and enable the
microprocessor retest.
2. Microprocessor 4.
3. Processor board.
82
BladeCenter HS40 Type 8839: Hardware Maintenance Manual and Troubleshooting Guide