IBM HS40 - BladeCenter - 8839, Maintenance And Troubleshooting Manual

Page: 89 / 172

POST error codes
The following table lists error codes that might be sent to the management module
for error logging as BMC pass-through error entries for the management module
system-error log (SEL).
Note: The syntax of error logging between the management module and the SEL
might be different. Local SEL error codes might differ from the SEL entries
logged by the management module for identical event types.
In the following error codes, X can be any number or letter.
Note: See Chapter 7, “Parts listing, Type 8839,” on page 105 to determine which components should be replaced by
a field service technician.
Error code/symptom FRU/action
0000
(Timer error)
1. Run diagnostics.
2. Battery.
3. I/O board.
0005
(CMOS checksum bad loading defaults)
Information only; no action required.
0012
(CMOS date/time not set)
Run the Configuration/Setup Utility program, and set the date and
time.
0040
(Refresh timer test failed)
1. I/O board
2. Processor board
0044
(DMA controller error)
I/O board
0045
(DMA-1 error)
I/O board
0046
(DMA-2 error)
I/O board
004C
(Keyboard/interface error)
I/O board
004D
(Primary master hard disk error)
1. Reset primary hard disk.
2. Run diagnostics.
3. Primary hard disk.
4. I/O board.
004F
(Secondary master hard disk error)
1. Reset secondary hard disk.
2. Run diagnostics.
3. Secondary hard disk.
4. I/O board.
0055
(Primary master drive - ATAPI
incompatible)
Primary master hard disk drive
0057
(Secondary master drive - ATAPI
incompatible)
Secondary master hard disk drive
005D
(ATA SMART failure error (dynamic string))
ATA drive
Chapter 6. Symptom-to-FRU index
79