IBM HS40 - BladeCenter - 8839, Maintenance And Troubleshooting Manual

Page: 67 / 172

Installation CD that comes with the BladeCenter unit. You can also get the
latest version of the drivers from the IBM Support Web site at
http://www.ibm.com/pc/support/.
With the storage expansion unit installed on your blade server, you can install up to
two hot-swap SCSI hard disk drives in the expansion unit and configure them for
embedded mirroring (RAID level 1). Each SCSI device must have a unique SCSI
ID. This ID enables the SCSI controller in the expansion option to identify the
device and ensure that different devices on the same SCSI channel do not attempt
to transfer data simultaneously. The SCSI IDs for the hard disk drives in the
expansion unit are permanent (not configurable). Table 2 lists the SCSI IDs for the
hard disk drives that are installed in the expansion unit. See “Installing a SCSI
hot-swap hard disk drive” for instructions for installing hard disk drives.
Table 2. SCSI IDs for hot-swap hard disk drives in the expansion unit
Device SCSI ID
Drive bay 1 0
Drive bay 2 1
Note: SCSI ID 7 is usually reserved for the SCSI controller; however, this SCSI ID
is changeable through the ServeRAID
™
configuration program or the LSI
configuration utility program.
Use the Configuration/Setup Utility program in the blade server to enable or disable
the SCSI controller in the storage expansion unit. See the documentation that
comes with the storage expansion unit for information about configuring the storage
expansion unit and SCSI hard disk drives.
Installing a SCSI hot-swap hard disk drive
If you have installed a SCSI storage expansion unit on the blade server, you can
install up to two SCSI hot-swap hard disk drives in the bays in the expansion unit.
If a hot-swap hard disk drive in the expansion unit fails, you can replace it without
turning off the blade server. Therefore, you have the advantage of continuing to
operate your blade server while a hard disk drive in this unit is removed or installed.
Each hot-swap drive has two indicator LEDs. If the amber hard disk drive status
LED for a drive is lit continuously, that drive is faulty and must be replaced.
Each hot-swap drive that you plan to install must be mounted in a hot-swap-drive
tray. The drive must have a Single Connector Attachment (SCA) connector.
Hot-swap-drive trays come with hot-swap drives.
Chapter 4. Installing options
57