![background image](http://html1.mh-extra.com/html/hyundai/yanmar-3tnv82a-b/yanmar-3tnv82a-b_manual_2196324037.webp)
CONTROL SYSTEM
2-18
TNV Application Manual
Notes:
• The function of each pin is described later. Do not use the pins for other purposes than intended.
• Yanmar will not disclose nor customize the serial communication protocol.
• When the CAN bus is not used, jumper E30 to E39 to activate the CAN terminator resistor. (This is
required for connection of a service tool).
When the CAN bus is used, configure the bus according to the customer's CAN bus system.
• The intake air temperature, EGR temperature, FO temperature and reserved analog (atmospheric
pressure sensor) pins are not used and require no wiring.
Power
supply
Output
Sensor 5V
AVCC
E38
Voltage: Vcc±0.02 V (Vcc = 5.0±0.1V)
Output: 25 mA Max.
Sensor GND
GND-A
E28
Sensor 12V
AVB
E43
Voltage: Internally coupled to VB
Protected against dump surge
Input
Power supply 12V
VB
E48
Connected to main relay
Power supply GND
GND
E45
Connected to battery negative terminal
Power GND
GND-P
E47
Misc.
Misc.
Boot mode
BOOTSW
E29
Disabled
-
-
E46
Table 2-3 E-ECU I/O description
I/O
Type
Pin function/name
Symbol
No.
Description
00_Electronic_Control_System.book 18 ページ 2006年5月29日 月曜日 午後2時12分
Summary of Contents for Yanmar 3TNV82A-B
