50
―― 7. Main Menu
7.8.1.2 Replacing the Pump
〇 Information that must be written when replacing the pump.
1)Correction information:① Pump injection quantity correction value
2)Serial number:① Pump serial number
3) Additional information:① Calibration date(data inside PC),② Calibration device number(license key)
7.8.1.2.1 Writing Data Received from the PDM
When you replace the pump, you need to receive data from the PDM and write the correction values to the
ECU using the following procedure. First, you need to receive the pump correction data file(pump_serial.excp)
for the model name and serial number of your pump in advance.
<Procedure>
① Click the
Part exchange
button on the[Configuration]screen.
② On the sub-window that opens, checkmark
PDM
.
③ Click the
Load
button to load the file that has been received from the PDM and saved(select the
folder where the file is saved, select the file, and open it).
④ Click the
Write
button in the lower left part of the sub-window.
⑤ A report file is created after writing.
7.8.1.2.2 Manual Entry
As with replacing the ECU, you can enter data manually.
Figure 7-32 [System Installation]-[Configuration]-[Part exchange]/ PDM Screen
①
②
④
③
Summary of Contents for Yanmar 3TNV82A-B
