46
―― 7. Main Menu
7.8.1.1 ECU Exchange
〇 Information that must be copied when replacing the ECU.
1)Correction information:① Pump injection quantity correction value, ② Engine output correction value()
2)Configuration value
3)Calibration value
4)Tuning value
6)Serial number:① Engine serial number, ② Pump serial number
7) Additional information:① Calibration date(date inside PC),② Calibration device number(license key)
7.8.1.1.1 Copy from Old ECU
When the ECU program is running normally and the CAN communication functions normally, you can copy the
setting values(correction values, etc)from the current(old)controller to the new controller. Follow these
steps.
<Procedure>
① Click the
ECU exchanges
button on the[Configuration]screen.
② Checkmark
Copy
.
③ Click the
Read
button.
④ Click the
Save
button.
⑤ Choose a folder to save the file, enter a file name, and save it.
⑥ Close the program, turn off the ECU, and replace the ECU.
⑦ Turn on the ECU, start the tool program, and display this screen.
⑧ Checkmark
Copy
.
⑨ Click the
Load
button to load the file saved in ④ .
⑩ Click the
Write
button in the lower left part of the sub-window.
⑪ A report file is created after writing.
Figure 7-28 [System Installation]-[Configuration]-[ECU exchange]Screen
①
②,⑧
③
④
⑨
⑩
Summary of Contents for Yanmar 3TNV82A-B
