Hyundai Yanmar 3TNV82A-B, Manual

Page: 110 / 162

10
―― 5. Starting/Quitting the Software
5.2 Quitting the Software
You can quit the program in the same way as other Windows applications.
Before you turn off the system, you need to quit the PC program.
① or［File（F）］-［Exit］：The confirmation menu to quit the program appears.
②
Yes
：Click this button to quit the program.
Clicking the icon ③ stops communication temporarily without quitting the program. After adjusting the system,
click the icon again to continue monitoring.
Figure 5.4 Confirmation Screen for Quitting the Program
① ③ ②
5.3 Troubleshooting
If a communication error occurs and you cannot perform monitoring normally, check the following points, and
restart the program. Note that, if a connector is disconnected or the system power is turned off, the system may
not recover normally even if you restart the program. In this case, turn off the system once. If you cannot do so,
disconnect the diagnostic connector from the service connecter, and then connect them again. This operation
initializes the CPU inside the interface box, and restores the system operation.
① Isn't the cable disconnected? Isn't the cable broken?
② Is the system turned on?
③ Isn't the system in training mode?
④ Isn't the system in disconnect status?
⑤ Is the baud rate correct?