Hyundai Yanmar 3TNV82A-B, Manual

Page: 52 / 162

CONTROL SYSTEM
TNV Application Manual 2-33
Figure 2-19 illustrates the voltage levels at the input terminal for the low-side contact input. When the switch turns
on, the input terminal goes low for the switch with NO contact and goes high for the switch with NC contact.
Figure 2-19 Switches for low-side contact input
Unless otherwise specified, this manual assumes that switches with NO contact are used. This means that
turning on the switch activates the corresponding function.
Selection of NO switch or NC switch is allowed by using mapping plug-ins. Table 2-15 lists contact input
terminals for which a NO or NC switch can be selected.
Contact output
There are two schemes for contact output of the E-ECU: High-side output and Low-side output. See
Figure 2-20 See Table 2-3 for the allowable sink current and source current of the contact outputs.
In this manual, output transistor ON is referred to as logical "1" and output transistor OFF as logical "0". In
the high-side output scheme, the output terminal goes high when the transistor turns off. In the low-side
output scheme, the output terminal goes low when the transistor turns off.
Figure 2-20 Contact output schemes and output logics
VB
1.2k
Cont a ct inp u t
ECU
S W=ON
→
Low （ 1 ）
S W=OFF
→
High （ 0 ） S W=ON
→
High （ 1 ）
S W=OFF
→
Low （ 0 ）
S o u rce
c u rrent
10mA
( a ) Norm a lly open s witch inp u t ( b ) Norm a lly clo s e s witch inp u t
VB
1.2k
Cont a ct inp u t
ECU
S o u rce
c u rrent
10mA
VB
ECU
VB
lo a d
ECU
( a ) High- s ide cont a ct o u tp u t ( b ) Low- s ide cont a ct o u tp u t
Tr.=ON
→
Low(1)
Tr.=OFF
→
High(0) Tr.=ON
→
High(1)
Tr.=OFF
→
Low(0)
lo a d
Cont a ct o u tp u t
S ink
S o u rce
00_Electronic_Control_System.book 33 ページ ２００６年５月２９日 月曜日 午後２時１２分