![background image](http://html1.mh-extra.com/html/hyundai/yanmar-3tnv82a-b/yanmar-3tnv82a-b_manual_2196324105.webp)
5. Starting/Quitting the Software ――
5
5. Starting/Quitting the Software
5.1 Starting the Software
5.1.1 Connecting the System Components
① Connect the USB cable between the USB port of the PC and the USB port of the interface box.
② Connect the diagnostic cable to CN1(D-SUB 9P male connector)of the interface box.
③ Connect the diagnostic cable to the service connector of the engine.
Handle the cable carefully. The power to the interface box is supplied from the engine system. So, using a
damaged cable or shorting the terminals of the cable connecter is highly dangerous.
5.1.2 Turning on the Devices
There is no specific order to turn on the devices. However, the engine system must be on(the ignition key is
on)before you start the application software except when you use it in training mode.
5.1.3 Installing the USB Driver
When you connect to the system for the first time after installing the application, you need to install the USB
driver.
When you connect to the system, the screen as shown below appears. Select "Install from a list of specific
location(advanced)" and click
Next>
.
Summary of Contents for Yanmar 3TNV82A-B
