HPE OfficeConnect 1920S 24G series, Management And Configuration Manual

Page: 197 / 209

Locator 197
 SNMP—Status and community configuration

Port Status and Port Summary Statistics—Port and trunk configuration details, summary, and sta-
tistics
 Trunk Configuration and Trunk Statistics—Trunk configuration details and flap count statistics

Flow Control and Storm Control Configuration—Enable/disable status
 Auto DoS Features—Enable/disable status

Web Configuration—HTTP and HTTPS status and timeout settings
 MAC Table—Address forwarding table and summary statistics

VLAN Configuration and VLAN Port Membership—Configured VLANs and membership details
 Port Mirroring Configuration—Enable/disable status and source and destination port configuration

IGMP Status—Enable/disable information and statistics
 LLDP and LLDP-MED Configuration—Global settings and per-port LLDP configuration and activity

Loop Protection Status— Per interface configuration and statistics
 Spanning Tree Bridge and Interface Status—Global and per-port configuration and status

Green Features (EEE) Configuration—Global and per-port enable/disable status and power con-
sumption data
 PoE Configuration— On switches that support PoE, global and per-port configuration and sched-
ule settings.
You can click Save As to save the Support File page content. The Support File page is saved as
HTML and is named support_file.html by default.
Locator
When you need to physically locate the switch, you can use this page to activate a blinking LED on the
switch. When enabled, the LED blinks for 30 minutes before being automatically turned off by switch
software. You can also use this page to disable the LED if the switch has been located.
To display the Locator page, click
Diagnostics > Locator in the navigation pane.
Figure 143. Locator Page
Select Enabled and click Apply to cause the Locator LED on the switch to blink for 30 minutes. The
Locator System LED in the Device View is illuminated and blinks orange while this feature is active.
This feature is disabled by default (see
“System LEDs” on page 16 ).
Note that this setting is not stored with the system configuration, so clearing the configuration will not
change this value. If the switch reboots, this value is reset to
Disabled .