HP E8402A, User And Service Manual, Page: 92 / 249

94 Programming the Enhanced Monitor Chapter 3
STATus:PRESet
The STATus:PRESet command sets the enable registers. The Operation and
Questionable Enable Registers are preset to 0, disabling all events. All other enable
registers are preset to 1s (except P5STBY and P5EXT in the
STAT:QUES:VOLT:ENABle register), enabling all events. The SCPI positive
transition filters are preset to 1s.
Comments
•
After executing this command, none of the events in the OPERation event
register or the QUEStionable event register will be reported as a summary bit
in the Status Byte.
•
This command does not clear or change any of the Events in the OPERation
status group or the QUEStionable status group.
•
If *PSC was set to 0 prior to power-down, then at power-on, the enable
registers are loaded from non-volatile memory. Therefore, any values that you
have stored (
SYSTem:NVSave command) are returned to the registers.
However, if *PSC was set to 1, then at power-on the factory defaults are
returned. The factory defaults are listed in the following table:
Reset Condition
*RST does not affect the status system.
Related
Commands
STATus:OPERation:ENABle, STATus:QUEStionable:ENABle,
STATus:QUEStionable:BLOWer:ENABle,
STATus:QUEStionable:CURRent:ENABle,
STATus:QUEStionable:TEMPerature:ENABle,
STATus:QUEStionable:VOLTage:ENABle
Register Default
Value
STATus:OPERation:ENABle 0
STATus:QUEStionable:ENABle 0
STAT:QUES:BLOWer:ENABle 7
STAT:QUES:CURRent:ENABle 487
STAT:QUES:TEMPerature:ENABle 32767
STAT:QUES:VOLT:ENABle 487
STAT:QUES:VOLT:PTR 511