HP E8402A, User And Service Manual, Page: 111 / 249

Programming the Enhanced Monitor 113
Chapter 3
STATus:QUEStionable:TEMPerature:LEVel? <slot>[,MIN|MAX]
The STATus:QUEStionable:TEMPerature:LEVel? query returns three integers
representing the present temperatures, in degrees Celsius, in the mainframe.
Parameters
Returned Data
Comments
•
When querying AMBient, MIN, or MAX temperature, the same temperature is
returned in all three values. The measurements returned for any <slot> are the
last measurements taken. In normal operation, this is a measurement taken
during the last 2 seconds. If a *TST? or CAL? are being performed, the
measurements returned by this query are the last measurements taken before
the long operation started. If the mainframe power is off, the measurements
returned by this query are the last measurements taken before power went
down.
•
Refer to “Setting Enhanced Monitor Limits” on page 37 for information on
selecting and using temperature limits.
Reset Condition
*RST does not affect the temperatures. It can affect the maximums and minimums
if a limit was set and not saved with the
SYSTem:NVSave
command.
Name Type Range Default Description
< slot> enum. OUT0…OUT12,
DELTa0…DELTa12
AMBient
none Last measured exhaust temperature
for slots 0 - slot 12
Last measured temperature change
above the ambient temperature for
slot0 - slot 12
Last measured entrance air
temperature
optional
parameter enum. MIN, MAX none Adding MIN or MAX to the query
returns the present threshold being
used to determine temperature
warnings.
Type Range Default Description
int16, int16, int16 -100 to +100 none
Temperature, in
°
C, from each of the
three sensors: front, middle, rear