HP E8402A, User And Service Manual, Page: 147 / 249

Programming the Enhanced Monitor 149
Chapter 3
SYSTem:NVRecall
SYSTem:NVRecall causes the enhanced monitor to reload many of its parameters
from non-volatile memory. This includes temperature limits, current limits, total
power limits, status enable settings, PSC flag, beep frequency, beep duration, system
name, and mainframe serial number. RS-232 settings are not recalled; they are
recalled only at power-on.
Comments
•
This command is very similar to SYSTem:NVDefault except that the settings
recalled are the last ones saved by the SYSTem:NVSave command and not the
factory defaults.The commands affected are:
Error Conditions
The following table lists the most common error conditions and causes. Error
numbers and corresponding messages can be found using
SYSTem:ERRor?
query.
Reset Condition
*RST has no effect
Related
Commands
SYSTem:NVSave
Register Register
STATus:OPERation:ENABle STAT:QUES:POW:LIM
STATus:QUEStionable:ENABle SYST:BEEP:FREQ
STAT:QUES:BLOWer:ENABle SYST:BEEP:TIM
STAT:QUES:CURRent:ENABle SYST:NAME
STAT:QUES:TEMPerature:ENABle SYST:SNUM
STAT:QUES:VOLT:ENABle HIST:UNIT:TIME
STAT:QUES:VOLT:PTR *PSC
STAT:QUES:CURR:LIM *ESE
STAT:QUES:TEMP:LIM *SRE
Number Message Probable Cause
-221 “Settings Conflict” The mainframe’s power is off.
-311 “Memory Error” Non-volatile memory is inaccessible.