HP E8402A, User And Service Manual, Page: 152 / 249

154 Programming the Enhanced Monitor Chapter 3
SYSTem:POWer:STATus?
SYSTem:POWer:STATus? returns three integers representing the status of the three
sources of power-up/power-down assertion. The three sources are the front panel
ON/STDBY switch, the diagnostic connector’s remote power lines, and the
SYSTem:POWer command.
Returned Data
Comments
The mainframe cannot power-off unless ALL three of these states are 0 (zero).
Reset Condition
*RST has no effect on this query.
Related
Commands
SYSTem:POWer
Type Range Default Description
<switch> unit16n 0, 1 none This indicates the front panel switch state. 1
indicates it is pushed in (power-on).
< auxRemote> unit16 0, 1 none The state of the Diagnostic connector’s
remote power signal. 1 indicates it is
connected to the remote power signal return.
Refer to “Using the Remote Power-On Pins”
on page 25 and “Diagnostic Connector” on
page 42
< software> unit16 0, 1 none The state of the software power-on
command (SYSTem:POW ON/OFF). 1
indicates that a software power-on command
is active.