HP AA979A - StorageWorks SAN Switch 2/8V, Administrator'S Manual, Page: 379 / 465

Fabric OS 5.3.0 administrator guide 387
To add zones (members) to a Zoning configuration
1. Connect to the switch and log in as
admin
.
2. Enter the
cfgAdd
command.
3. Enter the
cfgSave
command to save the change to the defined configuration.
To remove zones (members) from a zone configuration
1. Connect to the switch and log in as
admin
.
2. Enter the
cfgRemove
command.
3. Enter the
cfgSave
command to save the change to the defined configuration.
To delete a zone configuration
1. Connect to the switch and log in as
admin
.
2. Enter the
cfgDelete
command:
3. Enter the
cfgSave
command to save the change to the defined configuration.
To clear changes to a configuration
Use the
cfgTransAbort
command. When this command is executed, all changes since the last save
operation (performed with the
cfgSave
command) are cleared.
In the following example, assume that the removal of a member from
zone1
was done in error:
To view all zone configuration information
If you do not specify an operand when executing the
cfgShow
command to view zone configurations,
then all zone configuration information (both defined and effective) displays. If there is an outstanding
transaction, then the newly edited zone configuration that has not yet been saved is displayed. If there are
no outstanding transactions, then the committed zone configuration displays.
1. Connect to the switch and log in as admin.
switch:admin> cfgadd “newcfg”, “bluezone”
switch:admin> cfgsave
You are about to save the Defined Zoning configuration. This
action will only save the changes on the Defined configuration.
Any changes made on the Effective configuration will not
take effect until it is re-enabled.
Do you want to save Defined Zoning configuration only? (yes, y, no, n): [no] y
switch:admin> cfgremove “newcfg”, “redzone”
switch:admin> cfgsave
You are about to save the Defined Zoning configuration. This
action will only save the changes on the Defined configuration.
Any changes made on the Effective configuration will not
take effect until it is re-enabled.
Do you want to save Defined Zoning configuration only? (yes, y, no, n): [no] y
switch:admin> cfgdelete “testcfg”
switch:admin> cfgsave
You are about to save the Defined Zoning configuration. This
action will only save the changes on the Defined configuration.
Any changes made on the Effective configuration will not
take effect until it is re-enabled.
Do you want to save Defined Zoning configuration only? (yes, y, no, n): [no] y
switch:admin> zoneremove “zone1”,”3,5”
switch:admin> cfgtransabort