HP AA979A - StorageWorks SAN Switch 2/8V, Administrator'S Manual, Page: 138 / 465

140 Configuring advanced security
IP Filter policy enforcement
An active IP Filter policy is a filter applied to the IP packets through the management interface. IPv4
management traffic will pass through the active IPv4 filter policy, and IPv6 management traffic will pass
through the active IPv6 filter policy. The IP Filter policy applies to the incoming (ingress) management traffic
only. When a packet arrives, it is compared against each rule, starting from the first rule. If a match is
found for the source address, destination port, and protocol, the corresponding action for this rule is taken,
and the subsequent rules in this policy will be ignored. If there is no match, then it is compared to the next
rule in the policy. This process continues until the incoming packet is compared to all rules in the active
policy.
If none of the rules in the policy matches the incoming packet, the two implicit rules will be matched to the
incoming packet. If the rules still don’t match the packet, the default action, which is to deny, will be taken.
When the IPv4 or IPv6 address for the management interface of a switch is changed through the
ipAddrSet
command or manageability tools, the active IP Filter policies will automatically become
enforced on the management IP interface with the changed IP address.
NOTE: If a switch is part of a LAN behind a Network Address Translation (NAT) server, depending on the
NAT server configuration, the source address in an IP Filter rule may have to be the NAT server address.
Creating IP Filter policy rules
There can be a maximum of 256 rules created for an IP Filter policy. The change to the specified IP Filter
policy is not saved to the persistent configuration until a save or activate sub-command is run.
To add a rule to an IP Filter policy:
1.
Log in to the switch as admin
2. Type in the following command:
ipfilter --addrule < policyname > -rule < rule_number > -sip < source IP > -dp < dest port >
-proto < protocol > -act < permit | deny >
11 Any 123 UDP Permit
12 Any 600-1023 UDP Permit
Table 38 Default IP policy rules (continued)
Rule number Source
address
Destination
port
Protocol Action
policyname Specifies the policy name which is a unique string composed of a
maximum of 20 alphanumeric and underscore characters. The names
default_ipv4 and default_ipv6 are reserved for the default IP Filter
policies. The policy name is case-insensitive and always stored as lower
case.
-
rule
rule number Enter a valid rule number between 1 and the current maximum rule
number plus one.
-
sip
source IP Specifies the source IP address. For IPv4 filter type, the address must be
a 32-bit address in dot decimal notation, or a CIDR block IPv4 prefix.
For IPv6 filter type, the address must be a 128-bit IPv6 address in any
format specified by RFC, or a CIDR block IPv6 prefix.
-
dp
destination port Specifies the destination port number, or a range of port numbers, or a
service name.
-
proto
protocol Specifies the protocol type, either TCP or UDP.
--
act
<permit |
deny>
Specifies the permit or deny action associated with this rule.