HP 70340A, User Manual

Page: 386 / 445

650 650,"PG switch not set to 0;(650)"
ALC calibration data w as not sa v ed in EEPR OM b ecause the PG switch w as protecting
the EEPR OM from \writes". Op en up the signal generator and switch the PG switch
to 0.
651 651,"In v alid v ernier cal data for 1-20 GHz;(651)"
V alid v ernier calibration data is not a v ailable for the 1-20GHz band. If y ou need to use
this frequency range, see the explanation for error n um b er 4000.
652 652,"ALC term v erication after EEPROM write;(652)"
ALC v ernier calibration data w as not written in to EEPR OM correctly . T ry writing the
data in to the signal generator again.
653 653,"In v alid v ernier cal data for 0.01-1GHz;(653)"
V alid v ernier calibration data is not a v ailable for the 0.01-1GHz band. If y ou need to
use this frequency range, see the explanation for error n um b er 4000.
655 655,"PG switch not set to 0;(655)"
F actory frequency correction data w as not sa v ed in EEPR OM b ecause the PG switch
w as protecting the EEPR OM from \writes". Op en up the signal generator and switch
the PG switch to 0.
656 656,"F actory atness cal data v erication;(656)"
F actory frequency lev el calibration data w as not written in to EEPR OM correctly . T ry
writing the data in to the signal generator again.
657 657,"F actory atness cal data is in v alid;(657)"
A v alid factory frequency lev el calibration is not a v ailable for one or more of the
frequency bands and/or attenuator settings. See the explanation for error n um b er 4000.
670 670,"Meter p o w er input is out of range;(670)"
The ALC input is not a v alid lev el. The p o w er meter range may b e wrong. This is a
\p ermanen t" error.
700 700,"Hardw are driv er F requency limit;(700)"
The frequency en tered cannot b e generated b y the signal generator with the set of
options a v ailable.
701 701,"Lo syn thesizer set error;(701)"
The LO syn thesizer cannot b e set to the lev el requested. En ter a new frequency .
702 702,"Oset syn thesizer set error;(702)"
The Oset syn thesizer cannot b e set to the lev el requested. En ter a new frequency .
704 704,"YTO driv er set error;(704)"
The YIG oscillator cannot b e set to the lev el requested. En ter a new frequency .
706 706,"Lo w pass lter set error;(706)"
The Lo w pass lter cannot b e set to the requested setting. En ter a new frequency .
710 710,"LO syn thesizer w en t out of lo c k;(710)"
8-8 Error Messages
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com