Mechanical coulter pressure
Springs are attached in the area of the tractor
tracks. This can compensate the higher com-
paction caused by the tractor tracks.
Springs coulter pressure
With the two bores in the bracket and the two
bores in the parallel guide the coulter pressure
can be increased in 4 steps.
Front possibility = Pos. 1
Rear possibility = Pos. 4
The coulter pressure applied increases in this
area by the following values:
Item
2 springs
4 springs
1
10 kg
20 kg
2
23 kg
46 kg
3
30 kg
60 kg
4
45 kg
90 kg
Direction of travel
1
3
2
4
Positions 1-4
¾
Lift the machine.
¾
Pull the bolt out of the spring holder.
¾
Slide the spring holder with the spring to the
desired position.
¾
Insert the bolt in the new position. The locking
bow must point upwards.
The bows could otherwise be damaged at the
bottom and the pins could fall out.
The open spring end must face to the rear.
NOTE
¾
Adjust the same position on all springs.
¾
Maestro CV: Check the placement behind
the tractor tracks when starting work, see
chapter
Inspection
.
68
69
Summary of Contents for Maestro 12.45 CV
