Honda Activa SCV110, Service Manual Digest

Page: 6 / 230

1-1
1. GENERAL INFORMATION
SERVICE RULES 1-1
MODEL IDENTIFICATION 1-2
SPECIFICATIONS 1-3
TORQUE VALUES 1-8
TOOLS 1-10
LUBRICATION & SEAL POINTS 1-11
CABLE & HARNESS ROUTING 1-13
EMISSION CONTROL SYSTEMS 1-18
TUFFUP TUBE 1-20
1
SERVICE RULES
1. Use genuine Honda or Honda-recommended parts and lubricants or their equivalents. Parts that do not meet Honda’s
design specifications may cause damage to the scooter.
2. Use the special tools designed for this product to avoid damage and incorrect assembly.
3. Use only metric tools when servicing this scooter. Metric bolts, nuts and screws are not interchangeable with English
fasteners.
4. Install new gaskets, O-rings, cotter pins, and lock plates while reassembling.
5. When tightening bolts or nuts, begin with the larger diameter of inner bolts first. Then tighten to the specified torque diagonally
in incremental steps unless a particular sequence is specified.
6. Clean parts in cleaning solvent upon disassembly. Lubricate any sliding surfaces before reassembly.
7. After reassembly, check all parts for proper installation and operation.
8. Route all cables,electrical wires and wiring harness as shown in pages 1-13 to 1-17, Cable and Harness Routing.