Honda Activa SCV110, Service Manual Digest

Page: 136 / 230

FINAL REDUCTION
10-7
CRANKCASE ASSEMBLY SHAFT
ASSEMBLY
COLLAR
ATTACHMENT
CRANKCASE
ASSEMBLY
COLLAR
OIL SEAL
DRIVESHAFT INSTALLATION
Install the driveshaft into the transmission cover.
Position the assembly collar against the driveshaft
bearing inner race.
Thread the assembly shaft onto the driveshaft.
Hold the shaft and draw the driveshaft into the bearing
inner race by turning the nut.
TOOLS:
Crankcase assembly collar
070MF – KWP-110
Assembly collar attachment 070MF – KWP-120
Crankcase assembly shaft 070MF – KWP-130
Coat the circumference and lip of a new oil seal with
engine oil.
Install the oil seal into the left crankcase until the depth
from the crankcase end surface is 0 – 0.5 mm (0 – 0.02
in), using the special tools.
TOOLS:
Crankcase assembly collar
070MF – KWP-110
Assembly collar attachment 070MF – KWP-120
Crankcase assembly shaft 070MF – KWP-130
FINAL REDUCTION ASSEMBLY
Install the counter gear shaft and counter gear into the
transmission case.
Install the final shaft.
Install a new gasket and the dowel pins.
Install the transmission case onto the left crankcase.
FINAL SHAFT
COUNTER GEAR SHAFT/
COUNTERGEAR
GASKET
DOWEL PINS