Honda Activa SCV110, Service Manual Digest

Page: 123 / 230

KICKSTARTER/DRIVE AND DRIVEN PULLEYS/CLUTCH
9-14
Remove the snap ring and drive the ball bearing out of
the driven face.
Pack new ball bearing cavities with grease.
Drive the ball bearing into the driven face with the sealed
side facing down.
TOOL:
Bearing Driver
070MD – KPL-I100
Install the snap ring properly into the driven face groove.
Pack the inside of the driven face with 5.0 – 5.5 g of
grease.
Apply grease to a new needle bearing.
Press the needle bearing into the driven face with the
markings facing up.
TOOLS:
Bearing installer (Driven face)
070NC–KWP–410
INSPECTION
DRIVE BELT
Check the drive belt for cracks, separation or abnormal
or excessive wear.
Measure the drive belt width.
SERVICE LIMITS: 17.5 mm (0.69 in)
CLUTCH OUTER
Check the clutch outer for wear or damage.
Measure the clutch outer I.D.
SERVICE LIMITS: 125.5 mm (4.941 in)
SNAP RING/BALL BEARING
NEEDLE BEARING
NEEDLE BEARING
COG