'61HN252' by American Honda Motor Co. - Page 361 of 540
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
1 of 1
3/9/2008 11:13 PM
[2005-2008] [TRX500 FA/FGA]
FRONT DRIVING MECHANISM
Install the drive shaft by holding the inboard joint
Be careful not to
INBOARD JOINT
until the stopper ring seats in the groove of the dif-
damage the oil seal
ferential.
in the differential
gear case.
Make sure that the stopper ring is seated properly
by pulling out the inboard joint lightly.
Install the wheel hub/knuckle assembly over the
Do not get grease
WHEEL HUB/KNUCKLE ASSEMBLY
drive shaft and onto the suspension arms.
onto the shoe
Install hub nut, and temporarily tighten the nut.
linings.
Install and tighten each joint nut to the specified
torque and further tighten until its grooves align
with the cotter pin holes.
OUTBOARD JOINT
Install and tighten each joint nut to the specified
Do not get grease
NUT
torque and further tighten until its grooves align
onto the shoe
with the cotter pin hole.
linings.
TORQUE: 54 N·m (5.5 kgf·m, 40 lbf·ft)
Install new cotter pins.
COTTER PINS
Install the splash guard and tighten the bolts.
BOLTS
TORQUE: 11 N·m (1.1 kgf·m, 8 lbf·ft)
SPLASH GUARD
17-13