'61HN252' by American Honda Motor Co. - Page 446 of 540
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
1 of 1
3/9/2008 11:23 PM
[2005-2008] [TRX500 FA/FGA]
LIGHTS/METERS/SWITCHES
ACCESSORY SOCKET
INSPECTION
Remove the front fender
(page 2-11).
2P (BLACK) CONNECTOR
Remove the accessory socket 2P (Black) connector
from the frame.
Measure the voltage between the White/black (+)
and Green () wire terminals of the wire harness
side connector.
There should be battery voltage with the ignition
switch turned to ON.
If there is no voltage, check for brown fuse (10 A)
and an open circuit in the wire harness.
Remove the accessory socket cap.
BOTTOM CENTER (White/black)
Check for continuity between the White/black wire
terminal of the socket side 2P (Natural) connector
and bottom center terminal of the socket, and
between the Green wire terminal and side wall ter-
minal.
There should be continuity.
If there is no continuity, replace the accessory
socket.
SIDE WALL (Green)
REPLACEMENT
Remove the front fender
(page 2-11).
COVER
NUT
Loosen the nut and remove the accessory socket
from the front fender.
Install the retainer by aligning the holes with the
cover tabs, then install a new accessory socket and
tighten the nut securely.
Route the
Install the removed parts in the reverse order of
accessory socket
removal.
wire properly
(page
SOCKET
1-22).
RETAINER
22-8
