'61HN252' by American Honda Motor Co. - Page 93 of 540
http://services.honda.com/ServiceManual/SVC_MNL/61HN253/61HN2...
1 of 1
3/9/2008 10:41 PM
[2005-2008] [TRX500 FA/FGA]
MAINTENANCE
NUTS, BOLTS, FASTENERS
Check that all chassis nuts and bolts are tightened to
their correct torque values
(page 1-13).
Check that all cotter pins, safety clips, hose clamps
and cable stays are in place and properly secured.
WHEELS/TIRES
Check the tire pressure with the tire pressure gauge.
Tire pressure
should be checked
RECOMMENDED TIRE PRESSURE:
when the tires are
Front: Standard: 25 kPa (0.25 kg/cm
2
, 3.6 psi)
cold.
Minimum: 22 kPa (0.22 kg/cm
2
, 3.2 psi)
Maximum: 28 kPa (0.28 kg/cm
2
, 4.0 psi)
With cargo: 25 kPa (0.25 kg/cm
2
, 3.6 psi)
Rear: Standard: 25 kPa (0.25 kg/cm
2
, 3.6 psi)
Minimum: 22 kPa (0.22 kg/cm
2
, 3.2 psi)
Maximum: 28 kPa (0.28 kg/cm
2
, 4.0 psi)
With cargo: 25 kPa (0.25 kg/cm
2
, 3.6 psi)
Check the tires for cuts, embedded nails, or other
damage.
Measure the tread depth at the center of the tires.
Replace the tires when the tread depth reaches the
following limit.
MINIMUM TREAD DEPTH (Front/rear):
4.0 mm (0.16 in)
Raise the wheel off the ground and check the hub or
knuckle bearings for excessive play or abnormal
noise.
STEERING SHAFT HOLDER BEARING
Raise the front wheels off the ground and support
the vehicle.
Check that the handlebar moves freely from side to
side.
If the handlebar moves unevenly, binds, or has hori-
zontal movement, inspect the steering shaft holder
bushing and bearing
(page 14-25).
3-25
