Hioki PW8001-01, Instruction Manual

Page: 30 / 262

24
Basic Operation (Screen Display and Layout)
Measurement screen
The following is an example of the Measurement screen. Actual screens vary depending on the
instrument’s settings.
This section describes contents shown only on the Measurement screen. This area is called the
setting indicators.
7 7 8 8
6 6 5 5 1 1 2 2 3 3 4 4
11 11 12 12 10 10 9 9
1 1
Combined channels
Displays channels that have been combined in the same wiring
configuration.
p. 41
22
Synchronization
source
Displays the setting for the source that determines the period
(between zero-crossing points) that serves as the basis for
measurement.
Left: Synchronization source for the basic measurement items
Right: Synchronization source for the harmonic measurement
items
p. 58
33
Switching ranges
The top row indicates the voltage setting, while the bottom row
indicates the current setting.
[Auto] : Auto-ranging function enabled
[Manu] : Auto-ranging function disabled
p. 54
44
Scaling Shown when the VT ratios and CT ratios have been set. p. 63
55
Measurement upper
frequency limit
Measurement lower
frequency limit
[Upper] : Measurement upper frequency limit setting
[Lower] : Measurement lower frequency limit setting
p. 61
66
Data refresh interval Displays the data refresh interval setting. p. 57
77
Wiring mode
Displays wiring configuration settings. p. 41
88
Current sensor
connection terminals
[1] : Probe 1 is selected as the current sensor
[2]
: Probe 2 is selected as the current sensor
p. 34
99
Delta conversion
setting
Displays the operating state of the delta conversion function.
[∆]
: Delta conversion enabled
Blank: Delta conversion disabled
p. 33
10 10
LPF
Displays the low-pass filter setting. p. 60
11 11
PS Shown when the phase correction function is enabled. –
12 12
Average
Displays the average setting.
[Mov]
: Moving average
[Exp] : Exponential average
Blank: Disabled
p. 105
HIOKI PW8001A961-00