GW Instek APS-7000 Series, User Manual

Page: 5 / 193

SAFETY INSTRUCTIONS
5
Do not dispose electronic equipment as unsorted
municipal waste. Please use a separate collection
facility or contact the supplier from which this
instrument was purchased.
Safety Guidelines
General
Guideline
CAUTION

Do not place any heavy object on the APS-7000.

Avoid severe impact or rough handling that
leads to damaging the APS-7000.

Do not discharge static electricity to the APS-
7000.

Use only mating connectors, not bare wires, for
the terminals.

Do not block the cooling fan opening.

Do not disassemble the APS-7000 unless you are
qualified.
(Measurement categories) EN 61010-1:2010 specifies the
measurement categories and their requirements as follows. The
APS-7000 doesn’t fall under category II, III or IV.

Measurement category IV is for measurement performed at the
source of low-voltage installation.

Measurement category III is for measurement performed in the
building installation.

Measurement category II is for measurement performed on the
circuits directly connected to the low voltage installation.

0 is for measurements performed on circuits not directly
connected to Mains.
Power Supply
WARNING

AC Input voltage range:
115/230 Vac ± 15% (APS-7050, APS-7100)
230 Vac ± 15% (APS-7200, APS-7300)

Frequency: 50/60Hz

To avoid electrical shock connect the protective
grounding conductor of the AC power cord to
an earth ground.