APS-7000 Series User Manual
96
2.
The trigger control settings appear. The
settings are divided into Input Pin and Output
Pin.
Trigger input
settings
Exit
Trigger output
settings
Trigger Input Pin
1.
The Input Pin settings configure what action is
taken when the Trigger In pin on the J1
connector is high.
2.
Go to the
Action
setting using the scroll wheel
and press
Enter
. Choose what will happen
when the Trigger In pin is pulsed high(+5V)
and then press
Enter
to confirm.
None
No action is taken. Remote trigger
commands are accepted.
Output
Turns the output on or off when
triggered.
Setting
Sets a user-defined voltage and
frequency setting when triggered.
Preset
Loads a preset setting when
triggered.
SurgeDip
Triggers the surge/dip control.
3.
Go to the Width setting and set the minimum
pulse width to recognize the trigger input
pulse.
0
Minimum pulse width (5ms)
1~ 60ms
1~ 60ms pulse width.
Summary of Contents for APS-7000 Series
