GW Instek APS-7000 Series, User Manual

Page: 6 / 193

APS-7000 Series User Manual
6
Cleaning the APS-
7000 
Disconnect the power cord before cleaning.

Use a soft cloth dampened in a solution of mild
detergent and water. Do not spray any liquid.

Do not use chemicals containing harsh material
such as benzene, toluene, xylene, and acetone.
Operation
Environment

Location: Indoor, no direct sunlight, dust free,
almost non-conductive pollution (Note below)

Relative Humidity: 20%~ 80%, no condensation

Altitude: < 2000m

Temperature: 0°C to 40°C
(Pollution Degree) EN 61010-1:2010 specifies the pollution degrees
and their requirements as follows. The APS-7000 falls under degree
2.
Pollution refers to “addition of foreign matter, solid, liquid, or
gaseous (ionized gases), that may produce a reduction of dielectric
strength or surface resistivity”.

Pollution degree 1: No pollution or only dry, non-conductive
pollution occurs. The pollution has no influence.

Pollution degree 2: Normally only non-conductive pollution
occurs. Occasionally, however, a temporary conductivity caused
by condensation must be expected.

Pollution degree 3: Conductive pollution occurs, or dry, non-
conductive pollution occurs which becomes conductive due to
condensation which is expected. In such conditions, equipment
is normally protected against exposure to direct sunlight,
precipitation, and full wind pressure, but neither temperature
nor humidity is controlled.
Storage
environment 
Location: Indoor

Temperature: -10°C to 70°C

Relative Humidity:
≤
80%, no condensation
Disposal
Do not dispose this instrument as unsorted
municipal waste. Please use a separate collection
facility or contact the supplier from which this
instrument was purchased. Please make sure
discarded electrical waste is properly recycled to
reduce environmental impact.