OPERATION
119
6.
Go to the
ON Phs
setting and set the starting
phase of the step. Not applicable for Trans1 or
Trans2.
ON Phase
ON, OFF
ON Phase
0~ 359º
Resolution
1º
7.
Go to the
OFF Phs
setting and set the end
phase of the step. Not applicable for Trans1 or
Trans2.
OFF Phase
ON, OFF
OFF Phase
0~ 359º
Resolution
1º
8.
Press the
Range
key repeatedly to set the
voltage range for the Vset parameter. The
range will be shown in the top corner, which
indicates that the simulation will be executed
within this voltage range.
Range
Range
LO(155V), MD(310V), HI(600V,
optional)
9.
Go to the
Vset
setting and set the Vrms level of
the step. If you input a Vset value that is not
within the voltage range, the input value will
be ignored.
Not applicable for Trans1 and Trans2.
Vset
0.00 ~ 310.0Vrms (range dependent)
(600V optional)
Summary of Contents for APS-7000 Series
