To fix NetCentral screen resolution problem
To fix the screen resolution problem seen with NetCentral on the Grass Valley Control Point PC,
do the following:
1. Go to Display properties (right mouse selection of properties on the display area)
2. Select Settings tab
3. Select the Advanced button
4. In the General tab, set the DPI setting to Normal size (96 DPI)
5. Restart the PC
Install SiteConfig on control point PC
NOTE: There might be a newer version of this document available. Check your product's release
notes and the Grass Valley website at www.grassvalley.com/docs for references to an updated
version that contains additional important information.
Work through the following topics to install the SiteConfig application on the control point PC.
About installing SiteConfig
SiteConfig uses a protocol that involves sending Ethernet broadcast messages to discover and
configure devices. To enable this protocol to work correctly, there must be unrestricted network
access between the PC that hosts SiteConfig and the devices to be discovered.
This is achieved if control network interfaces are all connected to the same switch or to multiple
switches interconnected with ISLs/trunks. If your site requires that other switches and/or routers be
in the network path, you must make sure that no restrictions are in place that block SiteConfig
protocols.
Also, do not install SiteConfig on a PC on which a drive from a managed device is mapped as an
administrative share (C$). For example, if you have a PC set up to run anti-virus software and for
this purpose you have network drives set up on the PC mapped to C$ shares on devices, then do not
use that PC to host SiteConfig and manage those devices.
For a given system, there should be just one instance of SiteConfig managing the system.
System requirements for SiteConfig host PC
The PC on which SiteConfig is installed must meet the following requirements:
Comments
Requirements
Microsoft Windows (Must be a U.S. version):
•
XP Professional Service Pack 2, Server 2003
•
Vista Enterprise Service Pack 1
Operating system
Minimum 512 MB, 1 GB recommended
RAM
Must have at least 128 MB memory
Graphics acceleration
02 February 2012
K2 SAN Installation and Service Manual
77
Setting up the K2 SAN infrastructure
Summary of Contents for K2 BASECAMP EXPRESS
