GRASS VALLEY K2 BASECAMP EXPRESS, Installation And Service Manual

Page: 291 / 366

4. Reconcile the locations assigned to the adapter names with the names as currently configured in
the Name column as follows:
• On systems with no 10 Gig network interface card installed, the required mapping of names
to locations is specified as follows:
Must be named as follows: The adapter name (as displayed in the Device
Name column) that is assigned to this
location…
Control Connection PCI bus 1, device 0, function 0
FTP-Streaming Connection PCI bus 1, device 0, function 1
Unused Connection 1 PCI bus 2, device 0, function 0
Unused Connection 2 PCI bus 2, device 0, function 1
• On systems with a 10 Gig network interface card installed, the required mapping of names
to locations is specified as follows:
Must be named as follows: The adapter name (as displayed in the Device
Name column) that is assigned to this
location…
Control Connection PCI bus 1, device 0, function 0
Unused Connection 0 PCI bus 1, device 0, function 1
Unused Connection 1 PCI bus 2, device 0, function 0
Unused Connection 2 PCI bus 2, device 0, function 1
FTP 10G Connection PCI bus 5, device 0, function 0
The 10 Gig network interface adapter must be named
FTP 10G Connection
. If it has
dual-ports, name the other connection
Unused Connection 3 10G
.
5. Proceed as follows:
• If all the names on this system are configured correctly to locations, skip the rest of this
procedure.
• If names on this system are not configured correctly to locations, for each adapter name
incorrectly configured, complete the remaining steps of this procedure.
6. Select the name in the Name column.
7. Select
File | Rename
to enter rename mode.
8. Type the name required for the location.
Next, reorder adapters.
Reorder adapters
Before beginning this task, make sure of the following:
• Adapters are named correctly according to their PCI bus location
• The control team is created
02 February 2012 K2 SAN Installation and Service Manual 291
Administering and maintaining the K2 SAN