GRASS VALLEY GV KORONA, User Manual, Page: 216 / 415

Switching Basics
Perform Aux Bus Transitions
218
Perform Aux Bus Transitions
1 Go to the User Setups, Suite Prefs, Resource Allocation menu.
2 Select the button(s) of the M/E partition you wish to allocate as the transition resource
for the aux bus.
3 Press the Aux Trans button in the Application column.
4 To change the transition rate, press the Aux Transition Rate parameter button, enter a
transition rate in the pop-up keypad, and press Enter .
The
Mix
and
Wipe
buttons on the Local Aux Module are now low tally.
5 Select an Aux bus on the Local Aux Module.
6 Press the Mix or Wipe button.
7 Press the Trans Lock button if you wish the mix/wipe transition to remain selected.
The aux bus is ready for transition to the next source.
Note: If you attempt an Aux bus transition while all allocated M/E
transition resources are in use, the Aux bus will perform a cut (not a
transition). For example if during a long transition where allocated
resources are all in use, and you switched sources during the transition,
the Aux bus would ‘cut’ to the selected source (it would not mix or wipe).