GRASS VALLEY GV KORONA, User Manual, Page: 215 / 415

Kayenne/Karrera/GV Korona
User Manual
Setting Wipe Transition Parameters
1 Go to the Wipes menu in the GV Switcher menu or press the Wipe button in the Multi-
Function Module and set the wipe parameters for the M/E(s) you will use for the aux
bus.
2 Select the wipe pattern to be used.
CAUTION: : When two partitions or more are released for aux bus wipe
transitions, it is very important to make all wipe parameters
the same because the dynamic assignment of M/E partitions
will not guarantee that an allocated partition will supply the
transition resource for a specific aux bus.
Allocating Resources and Setting up the Transition
Note: The DoubleTake option is required for Aux bus transitions.
Aux bus transitions use the allocated resources only during the transition. Any Aux bus can
then use the resource as it frees the resource after the transition.
When resources are allocated, the ME Mode menu still allows for the keyers to be used on
the resource. If keyers are cut on they will only be visible on the Aux bus during the
transition.
To allow both mix and wipe transitions, release the partition of a full M/E in the User Setups,
Suite Prefs, Resource Allocation menu.
Aux bus transitions can be recalled in a macro but are not E-MEMable, however the macro
can be embedded in an E-MEM.